Simply the best and safest solution to cover the gap between the impact screen and the frame!
Better Bumpers are shaped to maximize the foam area around the frame and taper back to frame the impact screen perfectly.
Dimensions: 4" deep (side) x 5" (backside, against the screen) x 6.25" (hypotenuse) x whatever custom length you desire.
Wrapped in an adhesive backed solution dyed no bleed impact resistant fabric. This fabric is unique in that it acts as the loop side of velcro and will adhere to any brand of hook side velcro/hook and loop tape.
Available with square or mitered corners or a combination thereof.
To install simply attach adhesive back hook velcro strips (provided) to your tarp clips to secure in place. You can also attach by sliding a piece of hook velcro through your bungees vertically and horizontally. For those with strut channel frames apply adhesive backed velcro to the frame and the bumper will easily mount to the frame.
To order: The back of the bumper that butts up against the screen is approximately 5". Since most screens have a 2" border around the perimeter, 2" of the 5" is designed to cover the border. The other 3" covers the bungees and the frame.
If you want bumpers with miters on both ends you would typically order 6" longer than the outside width dimension of your screen.
If you want a top or bottom bumper without miters (squared on both ends), you would typically order the width of your screen plus 6".
If you want side bumpers, mitered on top and square on the bottom, you would usually order the same length as the distance between the top of your screen and the top of the floor turf, plus 3".
Please note these are shipped rolled up and slight wrinkling can occur. Most relax out after the foam expands back to it’s original shape but some may remain.